1 / 8 Product image 1
Amazon product images. See this listing on Amazon
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON. THIS CONTENT IS PROVIDED ‘AS IS’ AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.
Price on Amazon.com as of 2026-11-01 20:39 UTC, and subject to change.
An all-in-one car seat with 3 modes: rear-facing harness 5 to 40 lb, 19 to 40 in; forward-facing harness 30 to 65 lb, 34.4 to 49 in; belt-positioning booster (high-back) 40 to 100 lb, 43.4 to 52 in.
Opens Amazon.com in a new tab. As an Amazon Associate I earn from qualifying purchases.
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON. THIS CONTENT IS PROVIDED ‘AS IS’ AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.
The Disney Baby Grow and Go (CC253) is an all-in-one seat. The manual lists rear-facing from 5 to 40 lb and 19 to 40 in., forward-facing with the harness from 30 to 65 lb and 34.4 to 49 in., and booster use from 40 to 100 lb and 43.4 to 52 in. It expires 10 years after manufacture.
It suits a family that wants one seat from the newborn stage to booster use, with a Disney cover. The main trade-off is the lower anchor limit in this manual: above 40 lb the seat must be installed with the vehicle belt, plus the tether when forward-facing. Safety 1st lists the standard Grow and Go (CC409) with the same three ranges, but I would follow the CC253 manual for its own anchor limit rather than another Grow and Go guide.
A research summary of Safety 1st’s published specifications and manual, read . Not a hands-on test or a crash-safety rating.
This seat covers 3 stages, and a child has to meet every limit of the stage they are in. Safety 1st gives it a 10-year life from the date of manufacture, so check the date label before using a hand-me-down.
| Mode | Child weight | Child height | Minimum age | Conditions |
|---|---|---|---|---|
| Rear-facing harness | 5 to 40 lb | 19 to 40 in | Not published | — |
| Forward-facing harness | 30 to 65 lb | 34.4 to 49 in | Not published | — |
| Belt-positioning booster (high-back) | 40 to 100 lb | 43.4 to 52 in | Not published | — |
A child must meet every limit for the mode they use. The labels on your seat and its manual are the final word.
Every install is a fit between one seat and one vehicle. Read both manuals, and use a free inspection station if anything is unclear.
Safety 1st does not publish a width for this seat, so measure your back seat and compare it with the seat in a store before buying.
Mickey Sprinkle.
The manual gives two rear-facing methods, the lower anchor belt or the vehicle belt, never both at once. The belt goes under the seat pad, across the seat, in front of the buckle and out the other side of the rear-facing belt path. The tether stays stored rear-facing. For a child who cannot sit up unassisted, the Rear-Facing Level Line must be parallel with the ground in recline Position 3 or 2. A child who can sit up may ride more upright in Position 2. Behind a front seat, the car seat must touch that seat back or be as close as possible, and it should not move more than 1 in. at the belt path.
Source: Disney Baby Grow and Go All-in-One Convertible Car Seat (CC253) user guide (PDF)
Forward-facing use starts only once the child has outgrown rear-facing, and lasts until 65 lb, 49 in., or the fit checks fail. The tops of the ears must stay below the top of the headrest. The harness straps must be at or slightly above the shoulders. The manual says not to use the lower anchors for a child over 40 lb; the vehicle lap or lap/shoulder belt is used from there to 65 lb. When an anchor is available, the tether must always be attached and tightened. The seat goes in Position 1, upright, and Position 2 only if that is needed to sit flush against the vehicle seat back.
Source: Disney Baby Grow and Go All-in-One Convertible Car Seat (CC253) user guide (PDF)
For smaller infants the manual describes lower shoulder harness slots. Using them requires the head and body pillow, and the headrest must be in its lowest position. The pad comes off without removing the harness, but the straps must stay threaded in the hip slots, because the manual says they cannot be rethreaded if pulled out. Wash the pad and accessories separately in cold water on a gentle cycle with the harness cover fastening strips closed, no bleach, then tumble dry separately for 10 to 12 minutes on low heat. Spot clean the harness straps and buckle. The cup holders are top-rack dishwasher safe.
Source: Disney Baby Grow and Go All-in-One Convertible Car Seat (CC253) user guide (PDF)
In booster mode the buckle is removed and the chest clip, harness straps and buckle tongues are placed behind the headrest. Only the vehicle lap and shoulder belt holds the child, and the lower anchor belt and tether stay stored. The shoulder belt runs through the guide in the headrest. The manual says not to use the booster if the child's head is less than 5 in. below the vehicle roof. On aircraft the seat is certified only with the internal harness, on a forward-facing aircraft seat, and a window seat is recommended. It must not be used more than 10 years after the date of manufacture.
Source: Disney Baby Grow and Go All-in-One Convertible Car Seat (CC253) user guide (PDF)
Each campaign naming this family was read against this model’s numbers and build dates, and none covers it. Still check your seat’s model number and date of manufacture before use, especially on a used seat.
Rear-facing is 5 to 40 lb and 19 to 40 in., forward-facing with the harness is 30 to 65 lb and 34.4 to 49 in., and booster mode is 40 to 100 lb and 43.4 to 52 in. The child also has to meet the fit checks for each mode.
This manual says not to use the lower anchors for a child weighing more than 40 lb. Above that, install with the vehicle belt, and forward-facing, attach the tether whenever an anchor is available.
The manual says it is certified for aircraft use with the internal harness, on forward-facing aircraft seats. It is not certified as a booster, because aircraft seats have no shoulder belts.
Safety 1st lists the Grow and Go (CC409) with the same ranges: 5 to 40 lb and 19 to 40 in. rear-facing, 30 to 65 lb and 34.4 to 49 in. forward-facing, and 40 to 100 lb and 43.4 to 52 in. as a booster. CC253 has its own model number and manual, so I would follow the manual that came with the seat.
Safety 1st: Grow and Go All-in-One Convertible Car Seat (CC409) (opens in a new tab)
The manual says not to use it more than 10 years after the date of manufacture, which is printed on a label on the side of the seat.
Yes. The manual says to machine wash it separately in cold water on a gentle cycle, then tumble dry separately for 10 to 12 minutes on low heat and remove it immediately.
Answers refer to the model and manual version on this page. Check the instructions supplied with your seat.
Other all-in-one seats whose published weight and height limits overlap the Disney Baby Grow and Go All-in-One Convertible Car Seat (CC253).
| Mode | Weight | Height |
|---|---|---|
| Rear-facing harness | 5–40 lb | 19–40 in |
| Forward-facing harness | 30–65 lb | 34.4–49 in |
| Belt-positioning booster (high-back) | 40–100 lb | 43.4–52 in |
$219.99Simply Mickey 2 · Amazon price as of 2026-11-01 20:39 UTC, subject to change
| Mode | Weight | Height |
|---|---|---|
| Rear-facing harness | 5–40 lb | 19–40 in |
| Forward-facing harness | 30–65 lb | 34.4–49 in |
| Belt-positioning booster (high-back) | 40–100 lb | 43.4–52 in |
13% off$139.98List price $159.99Limited time dealGreen Gables · Amazon price as of 2026-11-01 20:39 UTC, subject to change
| Mode | Weight | Height |
|---|---|---|
| Rear-facing harness | 5–40 lb | 19–40 in |
| Forward-facing harness | 30–65 lb | 34.4–49 in |
| Belt-positioning booster (high-back) | 40–100 lb | 43.4–52 in |
$209.99Black Pepper · Amazon price as of 2026-11-01 20:39 UTC, subject to change
| Mode | Weight | Height |
|---|---|---|
| Rear-facing harness | 5–40 lb | 19–40 in |
| Forward-facing harness | 30–65 lb | 34.4–49 in |
| Belt-positioning booster (high-back) | 40–100 lb | 43.4–52 in |
$99.00Price on safety1st.com as of 2026-10-07 05:49 UTC, subject to change
